Wrap Tether

SKU:TT-WRAP
WLL:1 kg

The Wrap Tether is a temporary tool tether with self-bonding rubber tape wrapped around a Dyneema tether to form a secure D-Ring anchor point. The Dyneema tether itself is very narrow, meaning it can be used on smaller tool handles down to 14mm in diameter.

Available Options

SKUSizeQuantity 
TT-WRAP5 pack
TT-WRAP-MP15 pack

Product Information

The Wrap Tether is a temporary tool tether with self-bonding rubber tape wraps around a dyneema tether to form a secure D-Ring anchor point. The dyneema tether itself is very narrow, meaning it can be used on smaller tool handles down to 14mm in diameter. Easily removable.

• Semi-permanent
• Easily retrofit existing tools
• Reusable tether
• Easily Removable

Size Information

Tether length: 10 cm.
Comes with 5m Tether Tape roll.
WLL 1kg

5 Pack = Wrap Tether Dyneema 5 Pack 5 tethers, 1x tether tape Semi-permanent
15 Pack = Wrap Tether Dyneema 5 Pack 5 tethers, 1x tether tape Semi-permanent

Testing & Certification

All-in-one safety.

All Leading Edge tool tethering products are tested and certified in accordance with EN364-1992 test methodology. It conforms to the provision and scope of our testing and quality procedures as per the PPE Regulations (EU)2016/045, where applicable and relevant within the fit for purpose design parameters.

Safety Factors.

All certified Leading Edge products boast a whopping 47x safety factor. We purposefully over engineer our products to have greater resilience than a real world scenario would require — this gives them superior in-service lifespan and fully guarantees your safety in daily use.

Testing Methods.

All tool safety equipment classified as UKCA approved must surpass two rigorous testing methods.

Static Test.

We attach the product to an anchor point and apply pressure by hanging a weight from it. A product only passes if it is able to withstand the load for a minimum of three minutes without signs of damage or weakening.

Dynamic Drop Test.

We attach the product to an anchor point and apply pressure by hanging a weight from it. A product only passes if it is able to withstand the load for a minimum of three minutes without signs of damage or weakening.

Screenshot 2023-07-06 at 08.38.54
Screenshot 2023-07-06 at 08.38.52

Safety Factors

All certified Leading Edge products boast a whopping 47x safety factor. We purposefully over engineer our products to have greater resillience than a real wordl scenario would require — this gives them superior in-service lifespan and fully guarantees your safety in daily use.

Declaration of Conformity

Every item that leaves our factory comes with full documentation containing technical specifications, serial numbers, testing methods, working load limits and inspection results proving it has passed all necessary requirements for work at height.

Go to top